Description |
Inspection 1. Ignition "ON" 2. Manually operate the control switch and measure the voltage of blower motor. 3. Select the control switch to raise voltage until high speed. BLOWER speedManual VoltageAuto ...
Replacement 1. Disconnect the damper (B) from the glove box (A).Remove the glove box lift (C). 2. Remove the filter cover with pushing the knob. 3. Replace the air filter (B), install it after making sure ...
Specifications Type: Hall effect sensor Operation condition (°C)°F((-)40 ~ 150)) -40 ~ 302Air gap(mm)in.(0.95~1.65) 0.037 ~ 0.065 Output voltage(V)High1.18 ~ 1.68Low0.59 ~ 0.84 ...
Inspection with GDS Initialization and diagnosis sequence by using GDS equipment. Below content summarize the procedure for A/S using GDS. No.Procedure1Locate vehicle to flat plane2Tire check3IGN1 ON4Head lamp Low Beam ON5Connection with diagnostic tool6Initial command by diagnostic tool7Clear DTC Code8IGN1 ...