Kia Optima Hybrid: Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Description and Operation

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Description and Operation

Description
Overdrive clutch control solenoid valve(OD/C_VFS) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure to the overdrive clutch.

Underdrive Brake Control Solenoid Valve (UD/B_VFS) Repair procedures

Inspection 1. Turn ignition switch OFF. 2. Remove the air duct (A). Tightening torque: 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft) 3. Remove the air cleaner assembly. (1) Disconnect the breather hose ...

Overdrive Clutch Control Solenoid Valve (OD/C_VFS) Specifications

Specifications Direct control VFS [OD/C] Control type : Normal high type Control Pressure kpa(kgf/cm?, psi)500.14 ~ 9.81(5.1 ~ 0.1, 72.54 ~ 1.42)Current value (mA)50 ~ 850 Internal resistance (?)5.1 ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Engine Control Module (ECM) Schematic Diagrams


ECM Terminal And Input/Output signal ECM Terminal Function Connector [C100-K] PinNo.DescriptionConnected to1Power groundChassis Ground2Battery power (B+)Ignition Switch3Power groundChassis Ground4Battery power (B+)Main Relay5Power groundChassis Ground6Battery power (B+)Battery 7-8-?9Fuel Level Sender ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Rear Hub - Carrier Repair procedures


Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, rear wheel and tire from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damage to the wheel nuts when removing ...

© 2025 Copyright www.koptimatfhev.com