Kia Optima Hybrid: SRSCM / Seat Track Position Sensor (STPS) Description and Operation

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Restraint / SRSCM / Seat Track Position Sensor (STPS) Description and Operation

Description

The STPS operates via a non-contacting magnetic proximity sensing device combined with a simple electronic circuit resulting in the ability of producing two separate and distinct logic level signals.

The STPS output signal is altered by the proximity of a separate ferro-magnetic shunt, which is linked via the seat track. The logic signal produced is the result of the proximity device being activated or deactivated.

When the seat is in the forward position zone of the track, the sensor gives a low current (prohibit) signal. When the seat is in the rear positon zone of the track, it gives a high current (enable) signal.

Side Impact Sensor (SIS) Repair procedures

Removal Pressure Side Impact Sensor • Removal of the airbag must be performed according to the precautions/procedures described previously. • Before disconnecting the side impact sensor ...

Seat Track Position Sensor (STPS) Components and Components Location

Components ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Components and Components Location

Component Location 1. Power door mirror2. Power door mirror switch3. Power folding mirror switch ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Front Driveshaft Repair procedures

Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, front wheel and tire from front hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the wheel nuts when ...