Kia Optima Hybrid: Windshield Deicer / Description and Operation

Description
Windshield deicer system prevent windshield wiper from freezing in the winter season. It consists of deicer in the lower part of windshield, switch and relay. Body control module receives an input signal from the deicer switch, then controls relay. Operating condition is the same that of rear window defogger system.
Since the generator "L" is switched ON, if the deicer switch is ON, then deicer output is ON for 20 minutes.
Components and Components Location

Component Location 1. Windshield deicer relay (Built-in engine room relay box)2. Windshield deicer switch3. Windshield deicer4. Deicer connector ...

Windshield Deicer Repair procedures

Inspection 1. Remove the cowl top cover. (Refer to the wiper) 2. Disconnect the windshield deicer connector (A) from the wiper motor linkage. 3. Check for continuity between the terminals of deicer lines. ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Seat Belt Buckle Switch (BS) Description and Operation


Description The SRSCM shall monitor the status of the driver and front passenger seat belt buckle. The SRSCM provides one pin each for the driver and front passenger seat belt buckle status input. The seat belt buckle circuit operates from internal boost voltage supplied by the SRSCM, and uses chassis ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Rear Stabilizer Bar Repair procedures


Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)     Be careful not to damage the hub bolts when removing the rear wheel & tire. 2. Loosen the nut and then remove the rear stabilizer link (B) from the rear lower arm ...

© 2024 Copyright www.koptimatfhev.com