Components |
1. Rear window glass moulding | 2. Rear window glass |
Replacement Removal • Put on gloves to protect your hands. • Use seat covers to avoid damaging any surfaces. 1. Remove the following items. • Front pillar trim (Refer to the BD group ...
Removal • Put on gloves to protect your hands. • Be careful not to damage the painted surface. 1. Remove the following items. • Roof moulding (Refer to the BD group- "Panoramaroof") ...
Inspection Throttle Position Sensor (TPS) 1. Connect the GDS on the Data Link Connector (DLC). 2. Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Throttle AngleOutput Voltage (V)TPS 1TPS 2C.T0.3 ~ 0.94.2 ~ 5.0W.O.T1.5 ~ 3.03.3 ~ 3.8 3. Turn the ignition switch OFF and ...
Inspection With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat switch. A : Power seat control switch B : Lumber support switchRemoval 1. Disconnect the negative (-) battery terminal. 2. Remove ...