Troubleshooting |
Symptom | Possible cause | Remedy |
Tachometer does not operate | Cluster fuse (10A) blown | Check for short and replace fuse |
CAN line faulty | Check the EMS | |
Tachometer faulty | Check tachometer | |
Wiring or ground faulty | Repair if necessary | |
Fuel gauge does not operate | Cluster fuse (10A) blown | Check for short and replace fuse |
Fuel gauge faulty | Check gauge | |
Fuel sender faulty | Check fuel sender | |
Wiring or ground faulty | Repair if necessary | |
Low fuel warning lamp does not light up | Cluster fuse (10A) blown | Check for short and replace fuse |
Bulb burned out | Replace bulb | |
Fuel sender faulty | Check fuel sender | |
Wiring or ground faulty | Repair if necessary | |
Water temperature gauge does not operate | Cluster fuse (10A) blown | Check for short and replace fuse |
Water temperature gauge faulty | Check gauge | |
Water temperature sender faulty | Check sender | |
CAN line faulty | Check the EMS | |
Wiring or ground faulty | Repair if necessary | |
Oil pressure warning lamp does not light up | Cluster fuse (10A) blown | Check for short and replace fuse |
Bulb burned out | Replace bulb | |
Oil pressure switch faulty | Check switch | |
Wiring or ground faulty | Repair if necessary | |
Parking brake warning lamp does not light up | Cluster fuse (10A) blown | Check for short and replace fuse |
Bulb burned out | Replace bulb | |
Brake fluid level warning switch faulty | Check switch | |
Parking brake switch faulty | Check switch | |
Wiring or ground faulty | Repair if necessary | |
CAN line faulty | Check the TCS/ABS (EBD) Check the Smart Junction Box(SJB) (Parking brake/Brake oil switch) | |
Open door warning lamp and trunk warning lamp do not light up | Memory fuse (15A) blown | Check for short and replace fuse |
Bulb burned out | Replace bulb | |
CAN line faulty | Check the Smart Junction Box(SJB) | |
Door switch faulty | Check switch | |
Wiring or ground faulty | Repair if necessary | |
Speedometer does not operate | Vehicle speed sensor faulty | Check the vehicle speed sensor (M/T) |
CAN line faulty | Check the EMS (A/T) | |
Seat belt warning lamp does not light up | Cluster fuse (10A) blown | Check for short and replace fuse |
Bulb burned out | Replace bulb | |
CAN line faulty | Check the BCM | |
Seat belt switch faulty | Check switch | |
Wiring or ground faulty | Repair if necessary |
Inspection 1. Check the audio remote control switch for resistance between terminals in each switch position. [Trip + Reset] SwitchConnector terminalResistance (±5%)Reset3 - 5 (LH)5.54 k?Trip3 - 5 (LH)2.54 ...
...
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • Do not remove the camshaft position sensor while engine is running or right after engine stops, or a scald by the flowed out engine oil may occur. [Bank 1 / Intake] ...
Components 1. Floor console assembly2. Gear boots3. Floor console upper cover4. Floor console extension cover [LH]5. Floor console extension cover [RH]6. Console rear bracket ...