Kia Optima Hybrid: SRSCM / Side Impact Sensor (SIS) Description and Operation

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Description and Operation

Description

Side Impact Sensor (SIS) system consists of two P-SIS which are installed at each center of the front door module (LH and RH) and two SIS which are installed at each center pillar nearby (LH and RH).

Side Pressure Sensor is also called P-SIS because it detects pressure due to collision at its mounting location.

Side Impact Sensor is also called A-SIS because it detects acceleration.

SRSCM decides deployment of the airbag and the time of deployment through the collision signal of the SIS when the collision occurred.

Front Impact Sensor (FIS) Repair procedures

Removal • Removal of the airbag must be performed according to the precautions/ procedures described previously. • Before disconnecting the front impact sensor connector, disconnect the ...

Side Impact Sensor (SIS) Components and Components Location

Components ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Knock Sensor (KS) Repair procedures

Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) terminal. 2. Drain the engine coolant (Refer to “Cooling System” in EM group). 3. Remove the radiator upper hose (Refer to “Cooling System” in EM group). 4. Disconnect the knock sensor connector (A). 5. Remove the ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Filler-Neck Assembly Repair procedures

Removal 1. Lift the vehicle. 2. Disconnect the fuel filler hose (A). 3. Disconnect the ventilation hose (B) from the fuel tank air filter. 4. Open the fuel filler door and then remove the filler-neck installation screw (A). 5. Remove the rear-LH wheel, tire, and the inner wheel house. 6. Remove the filler-neck ...