Description |
Circuit Diagram ...
Removal 1. Remove the shift lever knob. (Refer to the BD group - "Console") 2. Remove the console upper cover (A). 3. Disconnect the connector from the console upper cover. 4. Remove the multimedia jack ...
Replacement 1. Remove the rear wheel & tire. Tightening torque: 88.3 ~ 107.9 N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) Be careful not to damage the hub bolts when removing the rear wheel & tire. 2. Remove the sprit pin and castle nut and then disconnect the rear assist arm (A) from ...
Inspection 1. Disconnect the IMS control switch connector. 2. With the power IMS control switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the IMS control switch. Removal 1. Disconnect the negative (-) battery terminal. 2. ...