Kia Optima Hybrid: SRSCM / Front Impact Sensor (FIS) Description and Operation

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS) Description and Operation

Description
The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary purpose of the Front Impact Sensor (FIS) is to provide an indication of a collision. The Front Impact Sensor (FIS) sends acceleration data to the SRSCM.
SRS Control Module (SRSCM) Repair procedures

Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. (Refer to the Body ...

Front Impact Sensor (FIS) Components and Components Location

Components ...

Other information:

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Transaxle Control Module (TCM) Repair procedures


Inspection TCM Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harness connector as TCM side check point. If the problem is found, repair it. Specification: Below 1? 2. Test TCM Connector: Disconnect the TCM connector ...

Kia Optima Hybrid (TF HEV) 2016-2020 Service Manual: Rear Hub - Carrier Repair procedures


Replacement 1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove wheel nuts, rear wheel and tire from rear hub. Tightening torque: 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft)     Be careful not to damage to the wheel nuts when removing ...

© 2025 Copyright www.koptimatfhev.com